How to Replace Rear Shocks 11-14 Hyundai Sonata
Difficulty: Intermediate · About 100 min · Hyundai Sonata
Replace rear shock absorbers on a 2011–2014 Hyundai Sonata. The shock is serviced separately from the coil spring; support the suspension, align the through-bolt, and tighten fasteners to model-specific torque values.
Tools you will need
- Floor jack
- Jack stands
- 21mm socket
- 19mm wrench
- 14mm socket
- Ratchet
- Torque wrench
Parts and supplies
- Rear shock absorbers
Steps
Raise and support the rear
Loosen the wheel nuts with the vehicle near the ground, raise the rear at approved points, and support it on jack stands. Remove the wheel to reach the shock mounts.
Remove the old shock
Support the suspension arm, remove the lower through-bolt and upper body fasteners, then ease the shock out. Keep the coil spring seated and do not loosen its retaining hardware.
Prepare and install the new shock
Transfer the mount and boot to the replacement if required by its design. Seat the shock in the upper mount, align the lower holes, and install the through-bolt by hand before tightening to specification.
Refit the wheel and check
Reinstall the wheel, lower the vehicle, and torque its lug nuts in a star pattern to specification. Confirm the shock is seated and check for unusual noise on a short cautious drive.
Check your vehicle’s repair manual for exact specifications and fit.