How to Replace Front Window Regulator 97-01 Toyota Camry
Difficulty: Intermediate · About 70 min · Toyota Camry
Replace the front power window regulator on a 1997–2001 Toyota Camry by supporting the glass, exchanging the regulator, lubricating the tracks, and testing the window before reassembly.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- White Grease
- Painter's Tape
- 10mm Socket
- Ratchet
- Pick
Parts and supplies
- Front power window regulator
Steps
Remove the door panel
Switch off the ignition. Release the handle, armrest, and switch trim, unplug the window controls, and remove the panel screws and clips. Lift the panel away and peel back the water shield, then disconnect the interior handle rods if needed for access.
Support the glass and remove the regulator
Unplug the window motor and loosen the glass-retaining bolts. Raise the glass fully by hand and secure it with painter's tape. Remove the regulator and motor-brace fasteners, then guide the regulator out through the door opening.
Install and lubricate the replacement regulator
Apply white grease to the regulator's upper and lower tracks and gear teeth. Feed the regulator into the door, hang it on a mounting bolt, and install the remaining regulator and motor-brace fasteners securely.
Reattach the glass and test operation
Support the glass while removing the tape and lower it onto the regulator. Reinstall the two glass bolts, reconnect the motor and switch temporarily, and run the window through its travel to check smooth alignment.
Reinstall the handle and door panel
Switch off the ignition and refit the interior handle rods and metal shield. Return the water shield, reconnect the window switch, align the panel, and press its clips home. Reinstall the screws, bezels, and trim, then test the window and door controls.
Check your vehicle’s repair manual for exact specifications and fit.