How to Replace Rear Shocks 05-10 Pontiac G6
Difficulty: Intermediate · About 60 min · Pontiac G6
Replace a rear shock absorber on a 2005–2010 Pontiac G6, supporting the suspension and checking the replacement unit for correct fit before lowering the vehicle.
Tools you will need
- 21mm Socket
- 13mm Socket
- Socket Extensions
- Pry Bar
- Jack Stands
- 19mm Socket
- Ratchet
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear shock absorber
Steps
Raise the vehicle and remove the wheel
Loosen the lug nuts, raise the rear of the vehicle, and support it securely on stands. Remove the wheel to expose the shock mounting points.
Unbolt the upper shock mount
Support the suspension with a jack as needed. Remove the upper shock fasteners from inside the trunk or access area, keeping the shock from dropping unexpectedly.
Free the lower shock mount
Remove the lower shock bolt and nut. If the fastener is seized, apply penetrant and use controlled leverage; avoid damaging the knuckle or nearby brake lines.
Install the replacement shock
Position the new shock in the same orientation and align the upper and lower mounting holes. Start all fasteners by hand, then tighten them to the vehicle's specification.
Refit the wheel
Reinstall the wheel and hand-start the lug nuts. Lower the vehicle and tighten the lug nuts to the vehicle's specification in a star pattern, then check for clunks on a short test drive.
Check your vehicle’s repair manual for exact specifications and fit.