How to Replace Tail Light Circuit Board 02-06 Dodge Ram 1500
Difficulty: Intermediate · About 20 min · Dodge Ram
Replace the tail light circuit board on a 2002-2006 Dodge Ram 1500.
Tools you will need
- Flat blade screwdriver
- Phillips head screwdriver
- T25 Torx driver
Parts and supplies
- Tail light circuit board
Steps
- Remove the connector plate
Remove the two T25 Torx screws from the side of the taillight, pull it straight out, push the locking tab out with a flat blade screwdriver, disconnect the harness, then remove the connector plate's four screws.
- Install the new connector plate
Transfer the bulbs onto the new plate, push it into place, replace its four screws, connect the harness and refit the locking tab, line up the taillight and push it back into place, then replace the two T25 screws.
Check your vehicle’s repair manual for exact specifications and fit.