How to Replace Front Drivers Interior Door Handle 93-03 Ford Ranger
Difficulty: Intermediate · About 60 min · Ford Ranger
Replace the driver's interior door handle on a 1993–2003 Ford Ranger by removing the door panel, transferring the release cable, and securing the new handle.
Tools you will need
- Phillips screwdriver
- Flat blade screwdriver
- Drill and bit
Parts and supplies
- Driver interior door handle
- Replacement fastener
Steps
Remove the door panel
Remove the two screws in the pull handle and disconnect its switch wiring. Remove the remaining panel screws, then lift the panel away from the door.
Release the old handle
Carefully peel back the weather shield. Drill out the handle rivet, release the cable retainers, and withdraw the handle from the door opening.
Transfer the cable to the new handle
Release the cable clip from the old handle and rotate the cable end free. Connect it to the replacement handle, secure its clip, and refit the rubber cover.
Install the replacement handle
Position the handle in the door and secure it with a suitable replacement fastener. Check that the cable is seated and moves through its full range.
Reinstall the panel and test
Reseal the weather shield and reconnect the door wiring. Engage the panel slots and clips, reinstall its screws, and test the handle and latch before closing the door.
Check your vehicle’s repair manual for exact specifications and fit.