How To Replace Rear Hatch Handle 98-03 Toyota Sienna
Difficulty: Beginner · About 45 min · Toyota Sienna
Replace the rear hatch handle on a 1998–2003 Toyota Sienna by removing the hatch trim panel and transferring the latch connection and mounting hardware.
Tools you will need
- Flat blade screwdriver
- 10mm socket
- Ratchet
Parts and supplies
- Rear hatch handle
Steps
Remove the hatch trim
Pry out the grommet above the pull handle and remove the three 10mm bolts. Pull the trim panel away from the hatch and release the latch handle connection.
Remove the old handle
Remove the three 10mm nuts securing the rear panel and the two screws retaining the handle. Lift the handle from the panel and note how the latch mechanism attaches.
Install the replacement handle
Secure the replacement handle to the panel with its two screws. Reinstall the panel nuts and reconnect the latch handle mechanism.
Reinstall trim and test
Clip the hatch trim back into place, install its three bolts, and refit the grommet. Operate the handle and confirm the hatch latch releases properly.
Check your vehicle’s repair manual for exact specifications and fit.