How to Change Oil 09-19 Ford Fiesta
Difficulty: Beginner · About 45 min · Ford Fiesta
Change the oil and filter on a 2009–2019 Ford Fiesta, supporting the vehicle securely, using the specified oil grade and quantity, and checking for leaks and the final dipstick level.
Tools you will need
- Funnel
- Oil Filter Wrench
- Drain Pan
- 13mm Wrench
- Floor Jack
- Jack Stands
- Torque Wrench
Parts and supplies
- Engine oil
- Oil filter
- Drain-plug seal
Steps
- Inspect the engine and prepare
Park on level ground, check for existing leaks, and confirm the dipstick and tube are intact. Remove the oil-filler cap, chock the wheels, then raise and support the vehicle at approved points on jack stands.
- Remove the filter and drain the oil
Place a drain pan under the filter and loosen it with a filter wrench. Move the pan beneath the drain plug, remove the plug with a wrench, and let the crankcase drain fully before reinstalling the plug with a sound seal to specification.
- Install the replacement filter
Remove the old filter gasket if it remains on the housing and wipe the sealing surface clean. Lubricate the new gasket with fresh oil, thread the filter on squarely by hand, and tighten it according to the filter instructions.
- Refill and verify the oil level
Lower the vehicle and add the specified oil through a funnel, starting below the full capacity. Start the engine briefly, inspect the filter and drain plug for leaks, shut it off, wait for the oil to settle, and top up to the dipstick range.
Check your vehicle’s repair manual for exact specifications and fit.