How to Replace Window Regulators 02-08 Dodge Ram 1500
Difficulty: Intermediate · About 55 min · Dodge Ram
Replace a Dodge Ram window regulator while taping the glass securely, guiding the assembly into its tracks, and checking full travel afterward.
Tools you will need
- 10mm Socket
- Ratchet
- T40 Socket
- Phillips Head Screwdriver
- Painter's Tape
Parts and supplies
- Window regulator
Steps
Remove the door panel
Remove the handle fastener and panel screws, disconnect the window switch, and lift the panel away. Remove the regulator bracket and carefully peel back the water shield.
Secure the glass and remove the regulator
Lower the glass enough to access its retainers, release it from the regulator, and tape it firmly in the raised position. Unplug the motor and guide the regulator out of its tracks.
Install the replacement regulator
Feed the new regulator into the door and seat it in its tracks. Connect the motor lead, tighten the regulator fasteners, lower the glass onto its clamps, and secure it.
Test and reassemble
Operate the window through its full range and inspect for smooth movement. Restore the water shield and bracket, reconnect the switch, and refit the door panel and handle trim.
Check your vehicle’s repair manual for exact specifications and fit.