How to Replace Window & Lock Switches 07-10 Hyundai Elantra

Difficulty: Intermediate · About 45 min · Hyundai Elantra

Replace the power window and door lock switch assembly on 2007–2010 Hyundai Elantra models by removing the front door trim panel and switch carrier.

Steps

1. Remove the door trim panel

   Turn the ignition off and protect the painted trim. Pry off the caps at the inner handle and pull cup, remove the exposed Phillips screws, then release the panel clips around the perimeter.

2. Disconnect the panel

   Ease the panel away without pulling on its wiring. Remove the speaker grille and unplug the speaker if needed, then disconnect the switch connector and set the panel on a protected surface.

3. Swap the switch assembly

   Remove the four screws holding the switch carrier. Push the carrier out from behind and release the switch from its panel, taking care not to crack the plastic tabs.

4. Refit the switch and panel

   Snap the replacement switch into the carrier and secure the carrier with its screws. Reconnect the harness, hook the door panel over the window ledge, and press each retaining clip into its opening.

5. Reassemble and test

   Reinstall the handle and pull-cup screws and their covers. Test each window and the lock switch with the door open before finishing, and check that the panel sits flush.

Check your vehicle’s repair manual for exact specifications and fit.