How to Replace Front Power Window Regulator Motor 93-09 Ford Ranger
Difficulty: Advanced · About 75 min · Ford Ranger
Replace the front power window motor and regulator on a 1993–09 Ford Ranger, controlling spring tension and securing the regulator with appropriate fasteners.
Tools you will need
- Gloves
- Hammer
- Flat blade screwdriver
- Rivet gun and rivets
- Drill bit set
- Phillips screwdriver
- Center punch
- Drill
- Painter's tape
- Metric socket set
Parts and supplies
- Window regulator and motor assembly
- Replacement rivets or approved fasteners
Steps
Remove the door panel
Remove the pull-handle screws and door-handle trim, disconnect the wiring plugs, and lift the panel away from its retainers.
Support the glass and remove the regulator
Peel back the inner liner carefully and center-punch the regulator rivets. Drill the rivets out, raise the glass, and tape it securely before unplugging the motor and removing the track bolts.
Remove the motor while controlling the spring
Hold the regulator gear and plate together to contain spring force. Remove the motor fasteners, separate the motor, and release stored tension in a controlled manner.
Install the replacement motor
Position the new motor against the regulator and secure it with its fasteners. Rotate the arm as needed and ensure the gear engages correctly before releasing support.
Install the regulator and window
Reinstall the assembly and track, securing the regulator with proper rivets or approved equivalent hardware. Reconnect the motor, remove the tape, lower the glass, and fasten it to the regulator.
Test and refit the door panel
Cycle the window fully to check for binding and confirm it stays in the track. Restore the inner liner, reconnect door wiring, and reinstall the door panel and handle trim.
Check your vehicle’s repair manual for exact specifications and fit.