How to Replace Rear Door Stopper 00-07 Toyota Highlander
Difficulty: Intermediate · About 60 min · Toyota Highlander
Replace the rear door check strap on a 2000–2007 Toyota Highlander, removing the speaker to reach the fasteners and restoring the window switch wiring afterward.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
- Trim Tool Set
Parts and supplies
- Rear door check strap
Steps
Remove the rear door panel
Pry off the pull handle and trim covers, remove the exposed screws, and release the panel clips. Lift the panel free and disconnect the window switch.
Remove the speaker
Unbolt the speaker and unplug its harness. Set it aside to access the door-check strap inside the door cavity.
Remove the old door check
Support the door in an open position. Remove the body-side bolt and the two door-side fasteners, then slide the check strap out through the opening.
Install the replacement strap
Guide the new strap into its opening and align the mounting points. Start all three fasteners by hand, then tighten them to the vehicle's specification.
Reinstall the speaker and panel
Reconnect and secure the speaker. Reconnect the window switch, hang the panel on the door, and press its clips into place before reinstalling trim screws.
Test the door and window
Open and close the door to confirm the check holds it in position. Operate the window switch and latch, then verify the panel is firmly attached.
Check your vehicle’s repair manual for exact specifications and fit.