How to Replace Fog Light and Bulb 00-03 Mercury Sable

Difficulty: Beginner · About 45 min · Mercury Sable

Replace a fog light assembly or bulb on a 2000–2003 Mercury Sable by lowering the splash shield and aiming the lamp after installation.

Steps

1. Remove the splash shield

   Remove the 7/32 inch fasteners around the shield and its three 5/16 inch fasteners. Lower the shield to access the back of the fog lamp.

2. Replace the bulb if needed

   Twist the bulb socket counterclockwise and remove it from the housing. Pull the bulb from the socket, install a matching replacement, and lock the socket back into the lamp.

3. Remove and install the fog light

   Remove the three Phillips screws holding the lamp and withdraw it. Position the replacement in the opening and reinstall its three screws.

4. Aim and test the lamp

   Adjust the aiming screw in small increments to direct the beam appropriately. Reinstall the splash shield fasteners and test the fog light.

Check your vehicle’s repair manual for exact specifications and fit.