How to Replace Fog Lights 04-05 Ford Ranger
Difficulty: Intermediate · About 35 min · Ford Ranger
Replace a fog light assembly on a 2004–2005 Ford Ranger by releasing the lamp from the bumper, preserving the adjuster setting, and checking the beam after installation.
Tools you will need
- 8mm socket and ratchet
- 11mm socket
- Needle nose pliers
Parts and supplies
- Fog light assembly
Steps
- Remove the old fog light
Remove the 8mm retaining bolt and use needle-nose pliers to take off the locking washers. Remove the two 11mm speed nuts, release the bulb without touching its glass, and guide the lamp out from behind the bumper.
- Install the replacement assembly
Hang the new lamp on its mounting studs and install the speed nuts and locking washers. Refit the bulb by its base, then reinstall the 8mm bolt.
- Set the adjuster and test the beam
Set the adjuster to approximately the original position, then switch on the fog lights to verify operation. Aim the beams according to the vehicle service information and local requirements.
Check your vehicle’s repair manual for exact specifications and fit.