How to Replace Front Bumper Valance 01-03 Ford Ranger
Difficulty: Beginner · About 3 min · Ford Ranger
Replace the front bumper valance on a 2001–2003 Ford Ranger by transferring its support clips and fog lights, then checking the valance is fully seated.
Tools you will need
- 8mm Socket
- Ratchet
- Flat Blade Screwdriver
- Slip-Joint Pliers
- Needle nose pliers
Parts and supplies
- Compatible front bumper valance
Steps
Disconnect and remove fog lights
Switch the lights off and unplug both fog-lamp connectors. Remove the lamp fasteners and place the lamps aside where their lenses will not be scratched.
Remove the old valance
Remove the valance mounting bolts and release its locking tabs. Move the license-plate bracket as needed, then pull the valance away from the bumper.
Transfer clips and support pieces
Remove reusable clips and the stiffener from the old panel without bending them. Fit these parts to the replacement valance in their matching locations.
Install the replacement valance
Position the valance and engage its tabs before installing the mounting bolts. Refit the fog lights, connect their wiring, and verify the valance and lamps are secure.
Check your vehicle’s repair manual for exact specifications and fit.