How to Replace Window Regulator 98-02 Honda Accord
Difficulty: Advanced · About 120 min · Honda Accord
Replace a window regulator on a 1998–2002 Honda Accord by supporting the glass, transferring the speaker and bracket, and checking window movement before refitting the panel.
Tools you will need
- 10mm socket
- Ratchet and extensions
- Flat blade screwdriver
- Phillips screwdriver
- Painter's tape
Parts and supplies
- Window regulator
Steps
- Remove the door panel
Remove the sail trim and panel screws, then unplug the switch panel. Release the latch bezel and door panel clips, unplug the courtesy lamp and harnesses, and set the panel aside.
- Support the window
Remove the water shield and speaker to access the regulator. Loosen the glass fasteners, raise the window fully, and secure it with painter's tape before disconnecting the motor lead.
- Remove and install the regulator
Remove the regulator and motor fasteners and withdraw the assembly. Feed the replacement into the door, secure its mounting points, reconnect the motor, and lower the glass onto the regulator mounts.
- Test and finish the door
Reconnect the switch temporarily and cycle the window to confirm smooth movement. Reinstall the speaker and bracket, reseal the water shield, reconnect the wiring, and refit the door panel and trim.
Check your vehicle’s repair manual for exact specifications and fit.