How to Replace Starter 2007-11 Honda CR-V
Difficulty: Intermediate · About 70 min · Honda Cr-v
Replace the starter on a Honda CR-V by disconnecting the battery first, supporting the vehicle safely, and reconnecting the high-current cable securely.
Tools you will need
- 10mm Wrench
- Floor Jack
- Jack Stands
- 12mm Socket
- 14mm Socket
- Ratchet
Parts and supplies
- Starter motor
Steps
Isolate the battery
Switch the ignition off and disconnect the negative battery terminal. Secure the cable away from the post to prevent accidental contact while working.
Remove the lower splash shield
Raise and support the vehicle at approved points. Release the splash shield and wheel-well fasteners, remove its bolt, and move the shield aside.
Remove the starter
Remove any support bracket and starter mounting bolts. Separate the starter carefully, then disconnect the solenoid plug and insulated battery cable from the unit.
Install the replacement starter
Connect the battery cable and solenoid plug to the replacement starter, ensuring the protective boot covers the terminal. Seat the starter and tighten its mounting hardware to the vehicle specification.
Reassemble and verify
Reinstall the bracket and splash shield, then reconnect the negative battery terminal. Start the vehicle several times and check for secure wiring and abnormal starter noise.
Check your vehicle’s repair manual for exact specifications and fit.