How to Replace Engine Starter 97-04 Ford Ranger
Difficulty: Intermediate · About 35 min · Ford Ranger
Replace the engine starter on a 1997-2004 Ford Ranger.
Tools you will need
- Ratchet
- 1/4 inch ratchet
- Socket extensions
- 8mm socket
- 10mm socket
- 13mm socket
Parts and supplies
- Engine starter
Steps
- Disconnect the battery
Loosen the negative clamp with an 8mm socket, disconnect the cable, and set it aside.
- Remove the old starter
Remove the ground strap's 13mm nut and let it hang aside, pull the red cap off the starter studs, remove the solenoid's 13mm bolt and the signal wire's 10mm nut, pull both wires off their studs, then remove the starter's two 13mm mounting bolts and pull it out.
- Install the new starter
Push it into place, connect the power wire and tighten its 13mm nut, connect the signal wire and tighten its 10mm nut, push the red cap back on, insert the two 13mm mounting bolts, then reconnect the ground wire and its 13mm nut.
- Reconnect the battery
Refit the cable and tighten the clamp with the 8mm socket.
Check your vehicle’s repair manual for exact specifications and fit.