How to Remove Washer Fluid Pump 06-12 Nissan Altima
Difficulty: Intermediate · About 4 min · Nissan Altima
Replace the washer-fluid pump on a 2006–2012 Nissan Altima by removing the bumper cover, draining the reservoir, and checking the pump grommet and spray after installation.
Tools you will need
- Flat Blade Screwdriver
- Plastic Fastener Remover
- 10mm Socket
- Ratchet
- Drain Pan
Parts and supplies
- Compatible washer pump
- Pump grommet, if worn
- Windshield washer fluid
Steps
Remove the bumper cover
Release the upper, wheel-well, and lower retainers and screws. Pull the bumper corners from their guides and lift the cover away with support.
Drain the washer reservoir
Unplug the level sensor and place a clean container below the reservoir. Release the sensor carefully, drain the fluid, then reinstall the sensor in its keyed orientation.
Remove the washer pump
Unplug the pump and disconnect its outlet hose. Pull the pump straight from the reservoir and inspect the rubber grommet for wear or damage.
Install the replacement pump
Seat the pump squarely in the grommet, reconnect the hose and electrical plug, and check the connection is secure.
Reinstall bumper and test
Align the bumper with its guides and restore all clips, screws, and shield fasteners. Refill the reservoir with washer fluid and check pump operation and leaks.
Check your vehicle’s repair manual for exact specifications and fit.