How to Replace Window Regulator 98-02 Oldsmobile Intrigue
Difficulty: Intermediate · About 60 min · Oldsmobile Intrigue
Replace a failed window regulator in a 1998–2002 Oldsmobile Intrigue while protecting the glass, door wiring, and moisture barrier. Confirm the regulator design and connector before ordering parts.
Tools you will need
- Socket extensions
- Flat blade screwdriver
- Phillips screwdriver
- Plastic trim tool
- T30 driver
- 10mm socket and ratchet
- Painter's tape
Parts and supplies
- Window regulator assembly
- Door panel clips, if any are damaged
Steps
Remove the door trim
Disconnect the switch trim and remove the fasteners in the interior handle. Release the door panel clips with a trim tool, lift the panel off, and carefully peel back the water shield.
Secure the window and release the regulator
Move the glass to reach its regulator fasteners, detach it, then raise and tape it securely to the door frame. Unplug the motor, remove the regulator fasteners, and work the assembly out through the access opening.
Install the replacement regulator
Transfer the motor or hardware only if the replacement design requires it. Guide the new regulator into the door, loosely fit its fasteners, lower the glass onto the mounts, and reconnect the wiring.
Test operation and refit the panel
Keep hands clear of the moving mechanism while testing the window through its travel. Correct any binding, then restore the moisture barrier, seat the panel clips, and reinstall the handle trim and switch panel.
Check your vehicle’s repair manual for exact specifications and fit.