How to Replace Front Brakes 07-17 Toyota Camry

Difficulty: Advanced · About 95 min · Toyota Camry

Replace the front pads and rotors on a 2007–2017 Toyota Camry, then confirm firm pedal feel and a correct brake fluid level.

Steps

1. Raise and remove the wheel

   Loosen the lug nuts slightly on the ground, chock the rear wheels, lift the front at approved points, and support it on jack stands. Remove the wheel and inspect the caliper, hose, and rotor condition.

2. Remove the caliper and rotor

   Remove the caliper fasteners and hang the caliper securely so the hose is not stretched. Remove the pads and bracket bolts, then lift away the rotor; keep the brake hose connected unless a proper bleeding procedure is planned.

3. Prepare the hub and brake hardware

   Clean the hub and bracket slides, inspect caliper pins and boots, and apply brake-safe lubricant only to designated sliding surfaces. Install the replacement rotor and bracket, then fit the new pads and anti-rattle clips in their proper locations.

4. Compress the piston and reinstall the caliper

   Retract the piston slowly using an old pad and clamp, watching the reservoir so it does not overflow. Position the caliper over the pads and tighten all fasteners to the vehicle specification, then reinstall the wheel and tighten the lug nuts to specification.

5. Check the pedal and test safely

   Pump the brake pedal until firm and verify brake fluid level before moving. Test the brakes at low speed in a safe area and stop immediately if the pedal is soft, a warning appears, or the vehicle pulls.

Check your vehicle’s repair manual for exact specifications and fit.