How to Replace Ignition Coil 01-03 Chrysler PT Cruiser
Difficulty: Intermediate · About 60 min · Chrysler Pt Cruiser
Replace the ignition coil, including removing the intake manifold for access, on a 2001-2003 Chrysler PT Cruiser.
Tools you will need
- 13mm socket
- Socket extensions
- Flat blade screwdriver
- 8mm socket
- 10mm socket
- Ratchet
- Block of wood
Parts and supplies
- Ignition coil
Steps
- Remove the old ignition coil
Remove the intake manifold's 13mm mounting bolts, disconnect the EGR tube with a 13mm socket, remove its 8mm bolt, remove the intake manifold's five 8mm bolts, lift the manifold and prop it with a block of wood, unplug the spark plug wires (labeling them if needed), disconnect the wiring harness, then remove the coil's four bolts and lift it out.
- Install the new ignition coil
Mount the new coil and bolt it in, connect the wiring harness, plug in the spark plug wires, carefully lower the intake manifold back into place (considering a new gasket), tighten its five 8mm bolts evenly, reconnect the EGR tube with its 8mm and 13mm bolts, then replace the 13mm mounting bolt.
Check your vehicle’s repair manual for exact specifications and fit.