How to Remove Reinstall Bumper Fascia 07-13 Nissan Rogue
Difficulty: Beginner · About 45 min · Nissan Rogue
Remove and reinstall the front bumper fascia on a 2007–2013 Nissan Rogue, disconnecting fog lamps if equipped and restoring the wheel liners and lower air dam.
Tools you will need
- Trim tool
- 10mm socket
- T20 driver
- Ratchet and extensions
Steps
Remove upper and wheel liner fasteners
Release the eight clips along the bumper top and the clips at both wheel liners. Remove the 10mm bolt inside each wheel well.
Release the lower fascia
Remove the lower plastic pins and the T20 screws along both sides of the bumper. Disconnect fog lamp connectors if fitted, then pull the fascia forward from its body retainers.
Position the bumper fascia
Lift the fascia into place and align its tabs with the body. Reconnect the fog lamp wiring if equipped and press the fascia tabs into their retainers.
Secure the fascia
Reinstall the upper clips, wheel well bolts, and liner clips. Align the lower edge with the air dam and reinstall the side T20 screws and lower plastic pins.
Check fit and lighting
Inspect the fascia gaps and confirm all retainers are seated. Test the fog lamps if equipped and check that the wheel liners are secure.
Check your vehicle’s repair manual for exact specifications and fit.