How to Replace Hood Release Cable 02-06 GMC Envoy XL
Difficulty: Advanced · About 150 min · Gmc Envoy
Replace the hood release cable on a 2002–2006 GMC Envoy XL by routing the new cable through the firewall and checking latch alignment and release tension.
Tools you will need
- 10mm socket and ratchet
- 7mm socket
- Flat blade screwdriver
- Wire or string
- Marker
- Assistant
Parts and supplies
- Hood release cable
Steps
- Mark and remove the hood latch
Apply lubricant to the latch, mark its current position, and remove its three 10mm fasteners. Lift the latch out and release the cable end from its retainer.
- Remove the interior release handle
Remove the driver kick panel and move the floor insulation aside. Remove the handle retaining nut and slide the hood release handle off its stud.
- Route out the old cable
Tie a guide wire to the hood end of the old cable. Release its routing clips and panels as needed, then pull the cable through the firewall while preserving the guide wire path.
- Feed the new cable
Tie the guide wire to the replacement cable and have a helper draw it through the firewall. Seat the grommet fully using a small amount of suitable lubricant and route the cable through its retainers.
- Reconnect the handle and latch
Install the release handle and interior panels, then route the cable to the latch and clip its end in place. Position the latch using the marks and reinstall its mounting fasteners.
- Adjust and verify the hood
Close the hood carefully and check alignment and latch engagement. Test the release handle; adjust latch position if tension or release is incorrect, then lubricate the latch and striker.
Check your vehicle’s repair manual for exact specifications and fit.