How to Replace Washer Fluid Pump 07-13 Nissan Rogue
Difficulty: Beginner · About 90 min · Nissan Rogue
Replace the washer pump on a 2007–2013 Nissan Rogue by removing the bumper cover for access. Catch washer fluid, reconnect both hoses correctly, and confirm the jets spray before finishing.
Tools you will need
- Trim tool set
- 10mm socket
- Ratchet
- T20 driver
- Drain pan
Parts and supplies
- Windshield washer pump
- Washer fluid
Steps
Remove the bumper cover
Release upper and wheel-liner clips, remove wheel-well bolts and lower Torx fasteners, then unplug fog lamps if equipped. Pull the cover evenly from its guides.
Remove the washer pump
Place a pan under the reservoir, unplug the pump, and ease it from its grommet. Let fluid drain, then disconnect both hoses while noting their positions.
Install the replacement pump
Connect both hoses to their original outlets and press the pump fully into the reservoir grommet. Reconnect its electrical plug and check hose routing for pinches.
Refit the bumper cover
Align the cover with its guides, reconnect fog lamps, and reinstall the wheel-well, upper, and lower fasteners. Check panel gaps and confirm every clip is engaged.
Fill and test the system
Fill the reservoir with suitable washer fluid and operate the washers. Check pump operation, hose connections, and spray pattern, correcting any leaks before driving.
Check your vehicle’s repair manual for exact specifications and fit.