How to Replace Rear Sway Bar Link 01-05 Honda Civic
Difficulty: Intermediate · About 30 min · Honda Civic
Replace the rear sway bar link on a Honda Civic, counterholding the studs and checking that the replacement clears nearby suspension parts.
Tools you will need
- Floor Jack
- Jack Stands
- 14mm Socket
- Vise-Grips
- 19mm Socket
Parts and supplies
- Rear sway bar link
Steps
Raise the vehicle and remove the wheel
Loosen the lug nuts while the tire is on the ground, raise and support the vehicle, then remove the wheel for access.
Remove the old link
Counterhold each link stud with locking pliers and remove the upper and lower nuts. Withdraw the link from the sway bar and suspension arm.
Install the replacement link
Position the new link and start its nuts by hand. Hold each stud to prevent spinning while tightening the hardware to the vehicle specification.
Reinstall the wheel
Refit the wheel and snug the lug nuts. Lower the vehicle and torque the fasteners to specification in a crossing pattern.
Check your vehicle’s repair manual for exact specifications and fit.