How to Replace Blower Motor Resistor 08-13 Nissan Rogue
Difficulty: Beginner · About 20 min · Nissan Rogue
Replace the blower motor resistor on a 2008–2013 Nissan Rogue by disconnecting its electrical plug, changing two screws, and checking fan speeds after reassembly.
Tools you will need
- Phillips screwdriver
- Flat blade screwdriver
Parts and supplies
- Blower motor resistor
Steps
- Disconnect the resistor harness
Locate the blower resistor and release its electrical connector lock. Pull the plug straight off and check its terminals for corrosion or heat damage.
- Remove the old resistor
Remove the two Phillips retaining screws and lower the resistor from its opening. Keep the screws together and compare the old and new parts before installation.
- Install the replacement resistor
Position the new resistor in the same orientation and align its mounting holes. Reinstall the two screws snugly and reconnect the wiring harness until its latch clicks.
- Test blower settings
Operate the HVAC blower at each available speed and confirm the settings work. Listen for unusual noise and make sure the connector remains seated.
Check your vehicle’s repair manual for exact specifications and fit.