How to Replace Front Sway Bar Link 08-14 Cadillac CTS
Difficulty: Intermediate · About 90 min · Cadillac Cts
Replace a front stabilizer link on a 2008–2014 Cadillac CTS. Move the ABS-wire bracket carefully, hold the joint stud while loosening its nuts, and secure all hardware to the exact vehicle specification.
Tools you will need
- Floor jack
- Jack stands
- 18mm socket
- 18mm wrench
- Locking pliers
- Torque wrench
Parts and supplies
- Front stabilizer link
Steps
Raise the vehicle and remove the wheel
Loosen the wheel nuts on the ground, lift at approved points, and support the vehicle on jack stands. Remove the wheel for access to the link.
Remove the old stabilizer link
Apply penetrant to the link nuts, hold each stud from spinning, and disconnect the lower and upper ends. Remove the ABS-wire bracket carefully and keep its wire out of the work area.
Install the replacement link
Insert the upper stud through the bar and secure it, then attach the lower end to the control arm. Refit the ABS-wire bracket and torque fasteners to vehicle specification.
Refit the wheel and inspect
Reinstall the wheel and tighten its nuts in a crossing pattern to specification. Lower the vehicle and verify the ABS wire is clear of the link before a cautious test drive.
Check your vehicle’s repair manual for exact specifications and fit.