How to Replace Rear Interior Door Handle 05 Chrysler 300
Difficulty: Beginner · About 30 min · Chrysler 300
Replace the rear interior door handle on a 2005 Chrysler 300 by removing the door trim, transferring the latch rod, and reinstalling the switch connector and retaining clips.
Tools you will need
- T20 Driver
- Phillips Head Screwdriver
- Door Panel Removal Tool
Parts and supplies
- Rear interior door handle
Steps
Remove the rear door panel
Switch off the ignition. Release the four side-panel push pins and remove the lower Phillips screws and trim covers. Lift the panel upward off the lock, disconnect the latch rod, and unplug the window-switch connector.
Remove the old handle
Remove the T20 screws at the back of the handle and release its retaining tabs from the panel. Push the handle assembly out without bending the surrounding panel.
Install the replacement handle
Fit the new handle into the panel and engage its retaining tabs. Reinstall the T20 screws securely, then connect the latch rod to the handle before putting the panel back on the door.
Reinstall the panel and test
Reconnect the window-switch plug and slide the panel onto the door lock. Press the clips into place, reinstall the lower screws and trim covers, and verify the handle releases the latch before closing the door.
Check your vehicle’s repair manual for exact specifications and fit.