How to Replace Strut Tower Brace 05-14 Chrysler 300
Difficulty: Intermediate · About 35 min · Chrysler 300
Install a strut tower brace on a 2005-2014 Chrysler 300.
Tools you will need
- 14mm wrench
- 13/32 inch drill bit
- 13mm socket
- 5.5mm hex wrench
- Torque wrench
- Drill
Parts and supplies
- Strut tower brace
Steps
- Install the strut brace
Pull up the cowl panel's push tabs, remove the three 13mm strut bolts on each side, set the brace over the bolts, jack up the front end, start the 13mm nuts by hand, lower the jack, then tighten and torque the nuts to about 30 ft-lb.
- Secure the brace to the chassis
Protect the area with a paper towel, drill a 13/32 inch hole in the chassis brace under the cowl, insert the bolt and washer between the brace and chassis bar, torque it to about 10 ft-lb with a 5.5mm hex key, then press the cowl panel's clips back in.
Check your vehicle’s repair manual for exact specifications and fit.