How to Replace Exterior Door Handle 93-97 Toyota Corolla
Difficulty: Intermediate · About 45 min · Toyota Corolla
Replace an exterior door handle on a Toyota Corolla by disconnecting the latch rods and transferring the lock cylinder before refitting the panel.
Tools you will need
- Phillips Head Screwdriver
- Flat Blade Screwdriver
- 10mm Socket
- Putty Knife
Parts and supplies
- Exterior door handle
Steps
Remove the door panel
Remove the interior handle screw and release its latch rod. Remove the pull-handle and switch trim, free the panel clips, and peel back the water shield without tearing it.
Remove the exterior handle
Remove the inner bracket fasteners and unclip the lock and latch rods from the handle. Remove the handle bolts, transfer the lock cylinder, and withdraw the old handle.
Install the replacement handle
Position the replacement with the lock cylinder aligned, start its fasteners by hand, and reconnect both rods to their original levers. Reinstall the inner bracket.
Test and reinstall the panel
Test the key, lock, and latch while the door remains open. Restore the water shield, reconnect the switch, align the panel clips, and refit the handle trim and screws.
Check your vehicle’s repair manual for exact specifications and fit.