How to Replace Washer Fluid Reservoir 97-01 Toyota Camry
Difficulty: Intermediate · About 75 min · Toyota Camry
Replace the windshield washer reservoir on a 1997–2001 Toyota Camry by removing the bumper cover, transferring the pump and level sensor, and refilling the new tank.
Tools you will need
- Windshield Washer Fluid
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- No. 2 Phillips Screwdriver
- Jack Stands
- Drain Pan
- 10mm Socket
- Ratchet
- Floor Jack
Parts and supplies
- Washer fluid reservoir
- Washer fluid
Steps
Safely raise the vehicle and remove the bumper
Park on level ground, chock the rear wheels, and raise the front using approved lift points. Support it on jack stands before working underneath. Remove the bumper's upper and lower fasteners, release the inner-fender retainers, and carefully pull the cover away from its side clips.
Drain and disconnect the washer reservoir
Place a drain pan beneath the reservoir and disconnect the washer hose so the fluid can drain. Unplug the pump and level sensor, release their retainers and seals, and unclip the wiring and hose from the tank. Remove the reservoir fasteners and lift the tank out.
Install the replacement reservoir
Position the new reservoir on its mounting stud and start its fasteners by hand before tightening them. Transfer the level sensor with its tab facing downward, seat the pump and its grommet, reconnect the electrical plugs, and clip the wiring and hoses back into their retainers.
Reinstall the bumper and refill
Return the wheel liner and bumper cover to their guides, reinstall all fasteners and clips, and lower the vehicle. Transfer the reservoir strainer if equipped, add washer fluid, and test both the pump and level warning while checking for leaks.
Check your vehicle’s repair manual for exact specifications and fit.