How to Replace Front Brakes 05-10 Pontiac G6
Difficulty: Intermediate · About 50 min · Pontiac G6
Inspect and renew the front pads and rotors on a Pontiac G6, following the correct fastener specifications and confirming safe brake operation.
Tools you will need
- Floor Jack
- Jack Stands
- 14mm Socket
- 15mm Socket
- Wire Brush
- Torque Wrench
Parts and supplies
- Front brake pads
- Front brake rotors, as required
Steps
Lift and inspect the brakes
Loosen the wheel fasteners before lifting, then support the vehicle securely and remove the wheel. Check pad thickness and both rotor faces for deep grooves or uneven wear.
Remove the pads and rotor
Remove the caliper fasteners and support the caliper so its hose is not strained. Take out the pads and bracket, then remove the rotor if it needs replacement.
Install replacement components
Clean the hub and bracket contact surfaces. Fit the rotor and bracket, lubricate only the intended sliding contact points, then install the pads and caliper using vehicle-specific torque values.
Finish and test
Reinstall the wheel and torque its fasteners to specification. Pump the brake pedal until firm and carry out a cautious low-speed brake check before normal driving.
Check your vehicle’s repair manual for exact specifications and fit.