How To Change Engine Oil and Filter 01-06 Hyundai Elantra

Difficulty: Beginner · About 60 min · Hyundai Elantra

Change the engine oil and filter on a 2001–2006 Hyundai Elantra, using the correct oil grade and fill amount and checking the filter seal and dipstick after startup.

Steps

1. Raise the vehicle and drain the oil

   Park on level ground, chock the wheels, and raise the car at approved points before supporting it on jack stands. Position a drain pan under the oil pan, remove the drain plug, and allow the oil to drain fully.

2. Remove the old oil filter

   Move the pan beneath the filter and loosen it with a filter wrench. Wipe the mounting surface clean and confirm the old gasket has not stayed attached to the engine.

3. Install the new filter and drain plug

   Coat the replacement filter gasket with fresh oil and thread the filter on squarely by hand. Reinstall the drain plug with a sound seal and tighten it to the vehicle specification.

4. Refill and verify the oil level

   Lower the car and add the specified oil through a funnel, starting below the full capacity. Start the engine briefly, check for leaks, shut it off, wait for the oil to settle, and bring the dipstick level into range.

Check your vehicle’s repair manual for exact specifications and fit.