How to Replace Blower Motor Resistor 01-04 Chrysler Sebring
Difficulty: Intermediate · About 25 min · Chrysler Sebring
Replace the HVAC blower motor resistor on a 2001–2004 Chrysler Sebring by lowering the passenger-side insulation, disconnecting the harness, and verifying the fan speeds.
Tools you will need
- Razor Blade / Gasket Scraper
- Phillips Head Screwdriver
- 7mm Socket
- Ratchet
Parts and supplies
- Blower motor resistor
Steps
Lower the passenger-side insulation
Switch off the ignition and work from the passenger footwell. Release the small insulation retainer by hand and lower the insulation enough to access the blower resistor without tearing the material.
Disconnect the resistor
Unplug the resistor wiring harness and remove its two 7 mm mounting bolts. Lower the resistor from the HVAC housing and inspect the connector for heat damage or melted plastic.
Fit the replacement resistor
If the original opening or housing requires modification for the replacement part, follow the part maker's instructions and remove only the specified material. Seat the new resistor, install its mounting bolts, and reconnect the harness securely.
Restore insulation and test fan speeds
Return the insulation to its original position and refit its retainer. Turn on the ignition and test each blower setting; if a speed remains inoperative, inspect the connector, fuse, and resistor compatibility before further use.
Check your vehicle’s repair manual for exact specifications and fit.