How to Replace Rear Exterior Door Handle 05-10 Chrysler 300
Difficulty: Advanced · About 70 min · Chrysler 300
Replace a rear exterior door handle on a Chrysler 300 while retaining the actuator and window guide alignment and testing the lock before closing the door.
Tools you will need
- T30 Bit
- 8mm Socket
- 10mm Socket
- Phillips Head Screwdriver
- Trim Tool Set
Parts and supplies
- Rear exterior door handle
Steps
Remove the interior panel
Release the panel clips and screws, lift the panel off its lock, and disconnect the switch. Carefully separate the water shield so it can be resealed.
Move the actuator and guide
Release the lock and latch rods, unplug the actuator, and remove its fasteners. Loosen the window guide and move it aside to reach the exterior handle.
Replace the exterior handle
Remove the handle retaining bolts and turn the handle out of the door. Seat the replacement, install its bolts, and refit the lock actuator, rods, and window guide.
Test and reassemble
Check the exterior handle, lock cylinder, actuator, and window guide before sealing the water shield. Reconnect the switch and reinstall the door panel and trim.
Check your vehicle’s repair manual for exact specifications and fit.