How to Install Rear Lower Transverse Toe Link 06-10 Ford Explorer
Difficulty: Intermediate · About 65 min · Ford Explorer
Replace the rear lower transverse toe link on a 2006–2010 Ford Explorer, marking the original fastener positions and supporting the suspension during link removal and installation.
Tools you will need
- 24mm Socket
- Socket Extensions
- Torque Wrench
- Hammer
- Rust Penetrant
- Jack Stands
- 19mm Socket
- 21mm wrench
- 24mm Wrench
- Paper Towels
- Ratchet
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear lower transverse toe link
- Wheel lug nuts
Steps
Remove the rear wheel
Loosen the lug nuts with the vehicle on the ground, then raise and support it securely. Remove the wheel to access the transverse toe link.
Mark and remove the old toe link
Mark the positions of both link fasteners and apply penetrant. Support the outer suspension with a jack, remove the link nuts, and tap the link free from its mounting points.
Install and align the replacement link
Position the new link in the same orientation and hand-start both fasteners, matching the alignment marks. Raise the suspension to approximate ride height before tightening the fasteners to vehicle specification.
Reinstall the wheel and arrange alignment
Refit the wheel and torque the lug nuts in a crossing pattern to specification. Because toe settings can change, have the rear alignment checked before normal driving.
Check your vehicle’s repair manual for exact specifications and fit.