How to Replace Blower Motor Resistor 95-01 Ford Explorer
Difficulty: Intermediate · About 120 min · Ford Explorer
Replace the blower motor resistor on a 1995–2001 Ford Explorer by moving the intake and washer bottle for access, then checking blower operation across the available speeds.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- 8mm Socket
- 10mm Socket
- Ratchet
- 11mm Socket
Parts and supplies
- Blower motor resistor
Steps
- Move intake parts and washer bottle
Remove the fastener holding the cruise-control motor and move it aside. Release the air-box clips, lift out the air filter and lower air-box section, then unbolt and carefully move the washer bottle for access.
- Remove the blower motor and resistor
Unplug the blower motor and disconnect its air tube. Remove the motor mounting bolts and lower the motor enough to reach the resistor, then remove the resistor fasteners and unplug its connector.
- Install the replacement resistor
Connect the replacement resistor to the harness and secure it in the housing. Reinstall the blower motor, tighten its fasteners evenly, and reconnect both the air tube and electrical connector.
- Restore surrounding parts and test
Reposition the washer bottle and air box, refit the filter, and secure the clips and cruise-control motor. Turn the ignition on and test the blower at each speed, confirming the wiring and ducts stay clear.
Check your vehicle’s repair manual for exact specifications and fit.