How to Replace Front Sway Bar Links 03-07 Cadillac CTS
Difficulty: Intermediate · About 90 min · Cadillac Cts
Replace the front stabilizer links on a 2003–2007 Cadillac CTS, counter-holding each stud while removing the nuts and tightening the new links to the vehicle specification.
Tools you will need
- 14mm Wrench
- Socket Extensions
- Torque Wrench
- 15mm Socket
- Rust Penetrant
- Jack Stands
- 19mm Socket
- Ratchet
- Floor Jack
- Locking Pliers
Parts and supplies
- Front stabilizer links
Steps
- Raise the front and remove a wheel
Loosen the lug nuts while the tire is on the ground. Lift the front at an approved point, support the car on jack stands, and remove the wheel to reach the stabilizer link.
- Remove the old stabilizer link
Apply penetrating oil to the link nuts and allow it to work. Remove the upper nut while counter-holding the stud; repeat at the lower end and use locking pliers only where there is a safe, undamaged surface to grip.
- Install the replacement links
Align the replacement link and start both nuts by hand. Hold the stud with a wrench while tightening the nuts to the vehicle specification, then check that the boots are not twisted or pinched.
- Reinstall the wheel and inspect
Mount the wheel and hand-start each lug nut. Lower the vehicle and torque the lugs in a star pattern to specification, then inspect the link for clearance from the wheel and suspension parts.
Check your vehicle’s repair manual for exact specifications and fit.