How to Replace Sway Bar Link 99-03 Nissan Maxima
Difficulty: Beginner · About 55 min · Nissan Maxima
Replace a front stabilizer link on a 1999–2003 Nissan Maxima by counterholding each stud as the nuts are removed, then tightening the new link at both mounting points.
Tools you will need
- 14mm Wrench
- 21mm Socket
- A Piece of Pipe (for leverage)
- Torque Wrench
- 15mm Socket
- Jack Stands
- Ratchet
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Front stabilizer link
- Wheel lug nuts
Steps
Remove the front wheel
Loosen the wheel nuts on the ground, raise and support the vehicle, then remove the wheel to expose the sway bar link.
Remove the old link
Hold the lower stud with a 14 mm wrench while removing its nut with a 15 mm socket. Repeat at the upper joint and pull the stabilizer link out.
Install the replacement link
Insert the new link into the upper and lower mounting points and start both nuts by hand. Counterhold each stud with the wrench while tightening the nuts to specification.
Reinstall the wheel and check
Mount the wheel and snug the lug nuts evenly. Lower the vehicle, torque the nuts to the vehicle's specification, and inspect the link for correct alignment.
Check your vehicle’s repair manual for exact specifications and fit.