How to Replace Rear Wheel Backing Plate 05-11 Honda Civic
Difficulty: Advanced · About 110 min · Honda Civic
Replace a rear brake backing plate on a 2005–2011 Honda Civic by removing the brake assembly and bolt-on hub, preserving the ABS sensor and brake hose routing, then reassembling and checking brake operation.
Tools you will need
- 14mm Wrench
- 12mm Socket
- Large C-Clamp
- Torque Wrench
- 14mm Socket
- 17mm Wrench
- Jack Stands
- Brake Parts Cleaner
- Rubber Mallet
- Flat Blade Screwdriver
- T30 Driver
- Ratchet
- Wire Brush
- Floor Jack
- 1/2 Inch Breaker Bar
- 22mm Socket
Parts and supplies
- Rear brake backing plate
- Hub fasteners
- Brake pads
Steps
Raise the vehicle and remove the wheel
Loosen the wheel nuts, chock the front wheels, and raise the rear securely on a jack stand. Remove the wheel and keep the fasteners together.
Remove the caliper and pads
Move the brake hose bracket aside as needed, then remove the caliper fasteners. Support the caliper without stretching its hose, remove the pads, and detach the caliper bracket.
Remove the rotor and ABS sensor
Remove the rotor retaining screws and lift the rotor off. Unbolt the wheel speed sensor and release it gently from its holder, keeping its wire and connector clear of the work area.
Remove the hub and backing plate
Remove the hub assembly fasteners from the rear of the knuckle and withdraw the hub. If corrosion holds it, use controlled force on the hub or fasteners without striking the ABS tone ring or damaging the axle threads.
Install the replacement backing plate
Remove the backing plate fasteners and lift the plate away. Clean the mounting surface, position the replacement plate in the correct orientation, and tighten its fasteners to the vehicle specification.
Reinstall the hub and brakes
Seat the hub assembly squarely and torque its fasteners to specification. Refit the ABS sensor, rotor, caliper bracket, pads, and caliper, keeping lubricant away from friction surfaces and restoring the hose bracket.
Install the wheel and verify the brakes
Reinstall the wheel and torque its nuts in a star pattern to specification. Pump the brake pedal until firm, inspect the sensor wire and hose routing, and confirm the ABS light performs its normal self-check before a cautious test.
Check your vehicle’s repair manual for exact specifications and fit.