How to Replace Front Interior Door Handle 05-10 Chrysler 300
Difficulty: Intermediate · About 35 min · Chrysler 300
Replace the front interior door handle on a 2005–2010 Chrysler 300 by removing the panel, transferring the latch rod, and reconnecting the courtesy light and switch wiring.
Tools you will need
- T20 Driver
- Phillips Head Screwdriver
- Trim Tool Set
- Pick
Parts and supplies
- Front interior door handle
Steps
Remove the front door panel
Switch off the ignition. Release the handle trim and remove the Phillips screw behind it, then free the panel clips and lower screws. Release the latch cable and disconnect the window switches and courtesy light before lifting the panel away.
Remove the old handle
Remove the T20 retaining screw and lift the handle from the panel. Check that the latch cable and handle clips are not damaged before transferring them to the replacement assembly.
Install the replacement handle
Seat the new handle in the panel and reinstall its T20 screw. Route the latch rod to the lever, engage its hook, and slide the retaining clip over the rod to secure it.
Reconnect wiring and reinstall trim
Reconnect the courtesy light, switch harnesses, and wiring retainers. Lift the panel over the door lock, press its clips home, reinstall the lower and handle screws, and refit the trim buttons. Test the handle, lock, and switches before closing the door.
Check your vehicle’s repair manual for exact specifications and fit.