How to Replace Front Power Window Regulator 06-11 Honda Civic
Difficulty: Intermediate · About 65 min · Honda Civic
Replace the front power window regulator on a 2006–2011 Honda Civic by supporting the glass, exchanging the regulator, and checking full window travel before refitting the door panel.
Tools you will need
- Razor Blade / Gasket Scraper
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
- Trim Tool Set
- Pick
Parts and supplies
- Front power window regulator
Steps
Remove the door panel and water barrier
Switch off the ignition. Release the switch panel and handle trim, remove the panel screws and clips, and lift the panel away. Disconnect the door-lock cables and actuator harness, remove the barrier plugs, and peel the water barrier back carefully.
Support the glass and remove the regulator
Loosen the two glass-to-regulator bolts and raise the glass by hand. Secure it at the top of the door with painter's tape. Disconnect the motor and remove the regulator fasteners, then guide the regulator assembly out through the door.
Install the replacement regulator
Feed the new regulator into the door and hang it on one mounting bolt. Align the remaining holes and secure the assembly, then reconnect the window motor harness and check that the tracks sit straight.
Reattach and test the glass
Support the glass while removing the tape and lower it onto the regulator. Reinstall both glass-retaining bolts, reconnect the window switch, and cycle the glass to confirm smooth movement and secure attachment.
Restore the barrier and door panel
Switch off the ignition, press the water barrier and its plugs back into place, and reconnect the lock cables and actuator wiring. Route the switches through the panel, engage the clips, and reinstall the panel screws and trim before retesting the window.
Check your vehicle’s repair manual for exact specifications and fit.