How to Replace Washer Fluid Pumps 05-16 Toyota RAV4
Difficulty: Intermediate · About 5 min · Toyota Rav4
Replace the windshield washer pumps on a 2005–2016 Toyota RAV4 by removing the front bumper cover, sealing each pump in the reservoir, and checking washer spray.
Tools you will need
- Windshield Washer Fluid
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Plastic Fastener Remover
- Drain Pan
- 10mm Socket
- Ratchet
Parts and supplies
- Compatible washer pump or pumps
- Pump grommet, if worn
Steps
Remove the bumper cover
Release the upper trim clips, bumper screws, wheel-well retainers, and lower shield fasteners. Pull both cover corners from their fender guides and support the cover as it comes away.
Remove the washer pumps
Place a pan below the reservoir and unplug each pump. Disconnect its outlet hose and pull the pump from the tank, allowing remaining fluid to drain.
Install the replacement pumps
Inspect each reservoir grommet and replace it if hardened or damaged. Reconnect the outlet hose and plug, then press each pump fully into its grommet.
Reinstall the bumper
Align the cover under the headlamps and engage both fender guides. Refit wheel-well, lower, and upper fasteners, followed by the engine-compartment trim.
Refill and test washers
Fill the reservoir with suitable windshield washer fluid. Operate each washer circuit and inspect the pump seals and hoses for leaks while confirming spray reaches the glass.
Check your vehicle’s repair manual for exact specifications and fit.