How to Change Oil 13-18 Subaru Forester
Difficulty: Beginner · About 60 min · Subaru Forester
Change the engine oil on a 2013–2018 Subaru Forester, using the correct oil capacity and grade, a new filter, and a level-ground dipstick check after the engine has run briefly.
Tools you will need
- 14mm Wrench
- Oil Filter Wrench
- Drain Pan
- Floor Jack
- Jack Stands
- Funnel
- Torque Wrench
- Cloth Rags
Parts and supplies
- Engine oil
- Oil filter
- Drain-plug seal
Steps
- Raise the vehicle and drain the oil
Park on level ground, chock the wheels, and lift the vehicle at approved points before supporting it on jack stands. Place a drain pan beneath the oil pan, remove the drain plug, and let the oil drain completely.
- Remove the old filter
Loosen the filter with an oil-filter wrench and allow it to drain into the pan. Clean the filter mounting surface and check that the old gasket did not remain attached.
- Install the new filter and drain plug
Lubricate the replacement filter gasket with fresh oil and thread the filter on by hand. Reinstall the drain plug with a sound seal and tighten it to the vehicle specification.
- Refill and verify the oil level
Lower the vehicle and add the specified oil through a funnel, starting below the full capacity. Start the engine briefly, check for leaks, shut it off, wait for the level to settle, and top up only as needed.
Check your vehicle’s repair manual for exact specifications and fit.