How To Replace Rear Window Switch 04-09 Subaru Outback
Difficulty: Intermediate · About 40 min · Subaru Outback
Replace the rear power window switch on a 2004–2009 Subaru Outback by removing the door panel, transferring the switch, and reconnecting the latch cables and wiring.
Tools you will need
- Phillips screwdriver
- Flat blade screwdriver
- Trim panel tool
Parts and supplies
- Rear window switch
Steps
- Remove the rear door panel
Release the small cover and handle trim, then remove the three Phillips screws. Use a trim tool to release the push pins, lift the panel away, and disconnect the electrical plug and door cables.
- Remove the old window switch
Turn the panel over and remove the two Phillips screws holding the switch. Release the switch retainers and separate it from its housing without damaging the panel or wiring.
- Install the replacement switch
Press the new switch into its housing until both retaining clips engage. Align the switch in the door panel and reinstall its two screws snugly.
- Reinstall the panel and test
Reconnect the door cables and electrical plug, align the panel, and press its clips into place. Reinstall the screws and trim covers, then test the window and door lock.
Check your vehicle’s repair manual for exact specifications and fit.