How to Replace Front Brakes 03-07 Honda Accord

Difficulty: Advanced · About 90 min · Honda Accord

Replace the front pads and rotors on a 2003–2007 Honda Accord and verify pedal pressure and braking performance before road use.

Steps

1. Raise the vehicle and remove the wheel

   Loosen the wheel nuts slightly on the ground, chock the rear wheels, raise the front at approved points, and support it securely. Remove the wheel and inspect the caliper, hose, and rotor for leaks or damage.

2. Remove the caliper, bracket, and rotor

   Remove the caliper slide bolts and support the caliper so its hose is not strained. Remove the bracket bolts and pads, then take off the rotor; do not open the bleeder unless the proper bleeding procedure will be performed.

3. Prepare and install the new components

   Clean the hub face and bracket pad channels, inspect the slide pins and boots, and apply brake-safe lubricant only to specified contact points. Install the new rotor and bracket, then seat the pads in their correct positions with the wear indicator placed as specified.

4. Reinstall the caliper and wheel

   Retract the piston slowly with an appropriate tool while monitoring brake fluid level, then position the caliper over the pads. Tighten bracket and slide fasteners to the vehicle specification, reinstall the wheel, lower the vehicle, and tighten lug nuts to specification.

5. Restore and test the brakes

   Pump the brake pedal until firm before moving the vehicle and verify the fluid level. Perform a low speed test in a safe area; stop and inspect if the pedal is soft, the car pulls, or any leak or unusual noise appears.

Check your vehicle’s repair manual for exact specifications and fit.