How to Replace Windshield Washer Reservoir 05-16 Toyota RAV4
Difficulty: Advanced · About 150 min · Toyota Rav4
Replace the windshield washer reservoir on a 2005–2016 Toyota RAV4 by removing the bumper cover, transferring the pumps and level sensor, then refilling and checking for leaks.
Tools you will need
- 10mm socket and extensions
- Ratchet
- Flat blade screwdriver
- Phillips screwdriver
- Fastener remover
- Drain pan
Parts and supplies
- Windshield washer reservoir
Steps
- Remove the bumper cover
Release the engine bay trim and bumper top retainers, then remove the wheel well and lower fasteners. Pull the bumper corners free from the fenders and support the cover as it comes away.
- Remove the old reservoir
Disconnect the washer pumps and level sensor, then release the wiring and hoses from their clips. Remove the filler neck and the three 10mm reservoir bolts, then lift the reservoir out.
- Install the replacement reservoir
Position the new reservoir and install its three mounting bolts. Refit the filler neck, wire and hose retainers, then inspect the pump and level sensor seals before seating both pumps and the sensor.
- Reinstall the bumper cover
Align the cover under the headlamps and engage its fender edges. Reinstall the wheel well screws and retainers, lower panel fasteners, upper screws, and engine compartment trim.
- Refill and test the washer system
Fill the reservoir with suitable washer fluid and close its cap. Operate the washers and inspect the pump seals and hose connections for leaks.
Check your vehicle’s repair manual for exact specifications and fit.