How To Replace Rear Window Wiper Motor 93-98 Jeep Grand Cherokee
Difficulty: Intermediate · About 2 min · Jeep Grand Cherokee
Replace the rear wiper motor on a 1993–1998 Jeep Grand Cherokee by removing the tailgate trim, aligning the wiper arm at park, and checking its sweep after reassembly.
Tools you will need
- 13mm Socket
- Phillips Head Screwdriver
- 1 Inch Wrench
- 8mm Socket
- Ratchet
Parts and supplies
- Compatible rear wiper motor
Steps
Remove the tailgate trim and arm
Remove the interior tailgate-panel screws and release the clips. Lift the wiper-arm cap, mark the blade's parked position on the glass, and remove the arm nut.
Disconnect and remove the motor
Loosen the motor retaining nut and remove its mounting bolts. Unplug the electrical connector and lift the motor away from the liftgate.
Install the replacement motor
Position the motor on its mount, reconnect its plug, and install the mounting bolts. Tighten the output nut securely without overloading the shaft.
Set the arm and test
Cycle the motor once to establish its park position, then align the arm with the mark and secure it. Reinstall the trim and test the blade for proper sweep.
Check your vehicle’s repair manual for exact specifications and fit.