How To Replace Power Steering Belt 01-06 Hyundai Elantra
Difficulty: Intermediate · About 90 min · Hyundai Elantra
Replace the power-steering belt on a 2001–2006 Hyundai Elantra, moving the alternator belt for access and adjusting both belts to their specified tension before reconnecting the battery.
Tools you will need
- 14mm Wrench
- 12mm Socket
- 14mm Socket
- 10mm Wrench
- 10mm Socket
- Ratchet
- 12mm Wrench
- Breaker Bar
Parts and supplies
- Power-steering belt
- Alternator belt
Steps
- Disconnect the battery
Switch the ignition off and disconnect the negative battery cable. Keep it clear of the terminal while working around the accessory drive.
- Release the alternator belt
Loosen the alternator adjuster fastener and pivot nut, then back off the adjuster with a wrench. Move the alternator inward and remove the belt from its pulleys.
- Remove the power-steering belt
Loosen the upper and lower power-steering pump fasteners enough to release tension. Slip the old belt off the pump and water-pump pulleys, noting its routing before removal.
- Install and tension the steering belt
Route the replacement belt over the water pump and steering-pump pulley. Pivot the pump to set belt tension to the vehicle specification, then tighten its upper and lower fasteners securely.
- Reinstall the alternator belt
Route the alternator belt over each pulley and adjust tension to the vehicle specification. Tighten the adjuster and pivot fasteners, then confirm both belts sit squarely in their pulley grooves.
- Reconnect power and check belt operation
Reconnect the negative battery cable and start the engine briefly. Observe the belts from a safe distance for tracking or squeal, and shut the engine off if either belt walks or rubs.
Check your vehicle’s repair manual for exact specifications and fit.