How to Replace Front Drivers Side Power Window Regulator 01-07 Toyota Highlander
Difficulty: Advanced · About 120 min · Toyota Highlander
Replace the front driver-side window regulator on a 2001–2007 Toyota Highlander by supporting the glass, transferring the motor, and testing the window before trim installation.
Tools you will need
- 10mm socket
- Ratchet
- T25 driver
- Phillips screwdriver
- Trim tool
- Razor scraper
Parts and supplies
- Front window regulator
Steps
- Remove the door panel and handle
Unplug the master switch and remove the door pull, sail panel, and handle trim. Remove the panel fasteners, release the clips, and disconnect the courtesy light and handle cables.
- Remove the speaker and support the glass
Peel back the vapor barrier and remove the speaker. Remove the glass fasteners, lift the glass out of the door, and set it on a padded surface.
- Remove the regulator and motor
Disconnect the motor wiring and remove the regulator mounting fasteners. Remove the T25 motor screws and transfer the motor to the replacement regulator.
- Install the regulator and glass
Hang the replacement regulator on its mounting point and secure its fasteners. Lower the glass into place, reinstall its bolts, and reconnect the motor harness.
- Test and reinstall the door trim
Cycle the window to verify smooth travel. Reinstall the speaker, reseal the vapor barrier, reconnect the handle cables and courtesy light, and refit the door panel and switch.
Check your vehicle’s repair manual for exact specifications and fit.